The following is sample output from the “show vpn-sessiondb detail l2l” command, showing detailed information about LAN-to-LAN sessions: The command “show vpn-sessiondb detail l2l” provide details of vpn tunnel up time, Receiving and transfer Data Cisco-ASA# sh vpn-sessiondb l2l Session Type: LAN-to-LAN Connection : 212.25.140.19 Index : 17527 IP Addr : 212.25.140.19 Protocol : IKEv1

The VPN tunnel shown here is a route-based tunnel. That is, I do NOT use proxy-ids in phase 2 for the routing decision (which would be policy-based), but tunnel-interfaces and static routes. This applies to both devices. The FortiGate firewall in my lab is a FortiWiFi 90D (v5.2.2), the Cisco router an 2811 with software version 12.4(24)T8. Lab Cisco AnyConnect: IPv6 Access through IPv4 VPN Tunnel Full IPv4 and IPv6 Tunnel. If so, there are only two steps to activate IPv6 for the VPN tunnel: The creation of an IPv6 pool and the allocation of that pool in the connection profile: If a connection is made to this connection profile (in many cases over an IPv4-only network), the AnyConnect client gets addresses from both protocols: In the VPN monitoring section of the Cisco ASDM, both IPv4 Cisco ASA VPN Hairpinning - Networks Training The ACL used for VPN Interesting Traffic on ASA2 must allow 192.168.2.0 towards “any IP”. This is required so that Site2 can access Internet hosts through the VPN tunnel. The ACL used for VPN Interesting Traffic on ASA1 must allow “any IP” towards 192.168.2.0.

Full IPv4 and IPv6 Tunnel. If so, there are only two steps to activate IPv6 for the VPN tunnel: The creation of an IPv6 pool and the allocation of that pool in the connection profile: If a connection is made to this connection profile (in many cases over an IPv4-only network), the AnyConnect client gets addresses from both protocols: In the VPN monitoring section of the Cisco ASDM, both IPv4

Oct 12, 2015 VPN Tunnel - 25128 - The Cisco Learning Network Jan 19, 2011

Restarting VPN Tunnels on Cisco – marktugbo.com

How can I reset a VPN tunnel on a Cisco ASA? - Network Choose the type of tunnel you're looking for from the drop-down at the right (IPSEC Site-To-Site for example.) Click on the tunnel you wish to reset and then click Logout in order to reset the tunnel. This will cause a temporary outage of the VPN connection, but in most cases I've seen, you're only doing this because the tunnel is already down. Site-to-site VPN Settings - Cisco Meraki